Page 11 © American Access Systems
GOOD TONES and ERROR TONES
The DK unit sounds an audible tone each time a key is pressed. The star (Å) key serves as the clear key
and a double tone is sounded when the star (Å) key is pressed. The pound (#) key is the exit key and exits
the programming mode any time it is pressed.
A "GOOD TONE" is an oscillating high tone. It is very distinct.
An "ERROR TONE" is represented by a single low tone. It also is very distinct.
THE RED AND YELLOW LEDs
One Red (on the top left of the keypad) and one Yellow (on the top right of the keypad) LED are on
the face of the unit.
The red LED illuminates during the relay(s) activation period.
The yellow LED illuminates anytime the unit is in the program mode.
During memory erasure or during the setup routine, Both LEDs will flash repeatedly until the routine or
erasure is complete.
PROGRAMMING THE DK UNIT
The PROGRAM MODE is used enter, delete, or change the codes or to set (energize) specific features of the
unit or how the DK unit interacts with other components in a system.
Access the PROGRAM MODE by entering the Master Code using the keypad. If the correct Master Code is
entered the unit will reply with a GOOD TONE and the Yellow LED will illuminate.
In the Program Mode you have approximately 30 seconds between key presses. If the
30-second time period is exceeded during programming, the unit will automatically exit the Programming
Mode. No damage is done to the programming. Simply complete the programming steps again.
NOTE: 1 2 5 1 WILL NOT OPEN THE GATE. 1 2 5 1 is the Master Code and allows access to the
programming functions only.
The Star (Å) and Pound (#) Keys
The star (Å) and pound (#) keys serve specific functions while in the IDLE or PROGRAM mode.
Pressing the star (Å) key will always clear the entry and emits a double tone when it is
pressed. FIX : IF YOU’VE HIT THE FORTH KEY IS IT COMMITTED TO MEMORY. Press the star (Å)
key if you want to delete entry. Note: Pressing the star (Å) key will erase an entire entry. For
example, if you enter 4 5 and realize that you wanted to enter 5 4, press the star (Å) key and
4 5 will be erased. It is not necessary to press the star (Å) more than one time.
The pound (#) key serves as the programming exit key. Pressing (#) will exit the program
mode. For example, enter the programming mode, enter the Access Codes you wish to add
to memory, and then press the pound (#) key to exit the programming mode.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce